Prototyping Center

Preparing Artwork

Frequently asked questions

Q. What if the printer I am using is not 600 dpi?
A. Just make two transparencies and lay them on top of one another.

Q. Where do I get transparencies from?
A. Use our Transparency Film.

Q. What is the maximum resolution achievable with your system?
A. The smallest track width can reach 0.08mm and separation should be 0.2mm


Photofabrication Process

Obtain Exposure and Photofabrication Kits Peel back protective backing off of presensitized copper clad board Place artwork on board Place acrylic weight on artwork and board Expose 5 min. with Exposure Kit Mix Developer 10:1 with water Brush developer over board (1 - 2 min) Rinse Etch with Ferric Chloride (4 - 5 min) Rinse








Quick Links
MSDS Listing
Material Safety Data Sheets

Products used to prepare artwork:

Transparency Film
Etch Resist Pen


MG AppGuide
MG Insider

Need more answers?

 

© 2000 - 2011 MG Chemicals. All rights reserved.  Site Map  Terms & Conditions  Contact Us